The BACK OF CAP Clamp for Cap Drivers is the easiest way to sew the back of caps when you already have a cap driver installed on your machine. The simple clamping action of the upper and lower window frames gives you the freedom to position the back section of the cap so that you can sew where you want. Along the bottom edge with a long curved design or a tall & wide design covering a larger area.
CLAMP FEATURES INCLUDE…...
Easy installation onto cap driver.
Spring clips to hold backing in place.
Single lever for locking & clamping.
Large window with centering points making centering the cap easy.
When the job calls for designs on both the front and back of caps, just run all the front design first and then the back design without changing over your machine setup from cap driver to sewing flat.
Framing Gage with Back of Cap Frame installed, ready for a backing.
Placing backing under clips, before loading a cap.
Positioning the back of the cap on to the clamp, checking location & alignment.
Back of Cap Frame latched and ready to take to the machine.
Framed Back of Cap loaded onto the driver and ready for sewing.
The Back of Cap Clamp is available for - TAJIMA - BROTHER - MELCO - TOYOTA
Instructional video: “How to frame up the back of a cap”